Mendel90 3D Printer

From ENTS
Revision as of 09:42, 3 August 2013 by Hov (Talk | contribs)

Jump to: navigation, search

Back to list of Equipment

Mendel90.jpg

Contents

Label

Mendel90 3D Printer http://ents.ca/index.php/Mendel90_3D_Printer

General

  • Owner/Loaner: ENTS
  • Make/Model: Mendel90
  • Usability: WORKING
  • Contact: User:Hov
  • Where: Main Workroom
  • Certification Needed: YES
  • Hackable: NO
  • Estimated Value: $600

Instructions

{{{Instructions}}}

Current State

Currently working with small issues. Interface is at http://members.ents.ca:5000

Who Can Certify You?

User:Hov User:grelli User:khawkings

Specifications

Equipment Settings

Modifications

The firmware has been modified to make extruder 1 (of extruders 0 and 1) behave like extruder 0. There was a magic smoke event that cooked the current limiting resistor for the extruder 0 heater.

What Could it Use?

Working on it

Known Problems

If the hot end stops making itself hot then unplug and plug back in the connectors for the hot end on the x-carriage (the 4 pin connectors to the protoboards)

Future Ideas

Firmware

File:Einstein-Marlin.zip

Personal tools
Namespaces

Variants
Actions
Navigation
Members
Toolbox